INTERIOR PANELS / TRIM UPPER INSTRUMENT PANEL REASSEMBLY
CAUTION / NOTICE / HINT
- HINT:
- ·
Use the same procedure for RHD and LHD vehicles.
·The procedure listed below is for LHD vehicles.
PROCEDURE
1.INSTALL GLOVE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)
| *1 | Stopper |
Push the stopper and insert the glove compartment door lock cylinder assembly to the glove compartment door assembly to install it.
55358K
2.INSTALL NO. 4 INSTRUMENT PANEL CUSHION
Install a new No. 4 instrument panel cushion using adhesive or double-sided tape in the location shown in the illustration.
55355
3.INSTALL NO. 1 INSTRUMENT PANEL CUSHION
Install 2 new No. 1 instrument panel cushions in the location shown in the illustration.
73960A
4.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
for Single Type Airbag:
for Dual Type Airbag:
82142A
5.INSTALL NO. 2 INSTRUMENT PANEL WIRE
for Single Type Airbag:
for Dual Type Airbag:
55833C
6.INSTALL CENTER INSTRUMENT PANEL REGISTER CONNECTOR
Install the center instrument panel register connector with the 2 screws <A>.
86860
7.INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
82142
8.INSTALL NO. 2 INSTRUMENT PANEL WIRE (w/ Speaker)
Attach the 8 wire harness clamps to install the No. 2 instrument panel wire.
55660
9.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
- HINT:
-
Use the same procedure to install the No. 2 instrument panel register assembly on the other side.
Attach the 3 claws to install the No. 2 instrument panel register assembly.
55085
10.INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Install the No. 2 heater to register duct sub-assembly with the 2 screws <A>.
55084E
11.INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Install the No. 1 heater to register duct sub-assembly with the 3 screws <A>.
55474B
12.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH
Attach the 2 clips to install the instrument cluster finish panel garnish.
58917B
13.INSTALL BOX BOTTOM MAT
Install the box bottom mat.
.png "close")